How Temperature Changes Sourdough Timing: A Practical Guide in °C and °F
At 24 °C bulk fermentation takes about 4 hours; at 20 °C it can take 6–8. How dough temperature drives timing, how to set it, and when to end bulk.
Temperature is the biggest single factor in sourdough timing. A typical white sourdough that finishes bulk fermentation in about 4 hours at 24 °C (75 °F) can need 6 to 8 hours at 20 °C (68 °F), and in a very hot kitchen it can run roughly twice as fast. The practical fix is to control dough temperature with your mixing water and to judge the end of bulk by rise and temperature rather than by the clock.
Why a few degrees matter so much
A sourdough is a partnership of wild yeasts and lactic acid bacteria, and they do not like the same conditions. In a widely cited study, Gänzle and colleagues found that a typical sourdough yeast (Candida milleri) grew fastest at about 27 °C, while the typical bacterium (Lactobacillus sanfranciscensis) peaked around 32–33 °C. Below about 26 °C, both responded to temperature in a similar way – which the authors suggest helps explain how the two coexist stably in long-kept sourdoughs.
Two practical consequences follow:
- Speed. Within normal kitchen temperatures, every degree changes how fast gas and acid are produced.
- Balance. Pushing much warmer tends to favour the bacteria over the yeast, which usually means more sourness relative to rise.
Bulk fermentation times by dough temperature
Maurizio Leo of The Perfect Loaf gives these illustrative bulk times in his guide to dough temperature, updated in March 2026:
| Dough temperature | Example bulk time |
|---|---|
| about 20 °C / 68 °F (cool kitchen) | 6–8 hours |
| 24 °C / 75 °F | 4–4.5 hours |
| 25 °C / 78 °F | 3.5–4 hours |
| 26 °C / 80 °F | 3–3.5 hours |
| 28–32 °C / 82–90 °F (very hot) | roughly twice as fast as normal |
These are examples for one style of dough, not rules. Flour, starter strength, the amount of levain and hydration all shift them. But the direction is reliable, and the size of the effect is the point: a winter kitchen can add hours.
Setting your dough temperature with water
The easiest lever you control is the temperature of the mixing water. The Perfect Loaf uses the classic desired-dough-temperature formula:
Water temperature = (target dough temperature × 4) − (levain temp + flour temp + room temp + friction factor)
The friction factor is the heat added by mixing: essentially zero by hand, larger in a stand mixer. Leo's worked example in Fahrenheit: aiming for 78 °F with a 78 °F levain, 74 °F flour, a 74 °F room and hand mixing gives (78 × 4) − (78 + 74 + 74 + 0) = 86 °F water.
The same formula works in Celsius. Example: target 25 °C, levain 24 °C, flour 20 °C, room 20 °C, hand mixing → (25 × 4) − (24 + 20 + 20 + 0) = 36 °C water.
Leo aims for roughly 24–25 °C for most white-flour doughs and goes slightly cooler, around 23 °C, for mostly whole-grain doughs, which tend to ferment faster.
Ending bulk: rise plus temperature
Because time is so temperature-dependent, Tom Cucuzza of The Sourdough Journey recommends a two-factor approach: measure dough temperature and percentage rise together. His examples assume the shaped dough then goes into the fridge:
| Dough temperature | Suggested end of bulk (rise) |
|---|---|
| about 27 °C / 80 °F | around 30% |
| about 21 °C / 70 °F | around 75% |
The logic: a warm dough keeps fermenting for a while after it goes into the fridge, so you stop it earlier. Cucuzza describes these as conservative starting points – if your loaf comes out under-proofed, raise the target by about 10% next time and note the result.
A straight-sided container with tape marking the starting level makes percentage rise easy to read.
The starter follows the same rules
Your starter is the first fermentation of the day, so it is just as temperature-sensitive. King Arthur Baking recommends keeping a starter at about 21–26 °C (70–78 °F) and expects a mature one to at least double in 6 to 8 hours after a 1:1:1 feed. In practice, the same starter can peak in four hours in July and nine in January.
Two levers help you time the peak:
- Feed ratio. A larger feed (1:5:5 rather than 1:1:1) gives the culture more food and pushes the peak later – handy for an overnight feed.
- Water temperature. Warmer water for a faster peak, cooler for a slower one.
The most useful thing you can do is measure your own starter: mark the jar after feeding and write down when it peaks and what the room temperature was. After a handful of feeds you know its rhythm. Riseplan does this bookkeeping for you – log the height you measured and it builds a rise chart, including how much faster your starter peaks when the room is warmer.
Planning a bake around temperature
Put it together and a sourdough schedule becomes a set of temperature-dependent blocks: starter to peak, bulk, shaping, cold retard, bake. The fixed parts are shaping, preheating and baking; everything else stretches or shrinks with the thermometer. When you plan backwards from the time you want bread, use your actual kitchen temperature, not the recipe's. Riseplan's planner does this backwards calculation and adjusts each fermentation step to the room temperature you enter, clearly labelled as a rule of thumb rather than a promise.
Quick reference
- Kitchen below 20 °C: use warmer water, find a warmer spot (oven with the light on), expect longer bulk.
- Kitchen 22–25 °C: the comfortable zone most recipes assume.
- Kitchen above 27 °C: cooler water, smaller levain percentage, end bulk earlier.
- Always: watch the dough, not the clock.
Choosing a tool to keep track of all this? See our honest comparison of sourdough starter apps.
A sourdough companion in grams and °C that works offline, with no subscription.
Download on the App StoreFrequently asked questions
What is the best dough temperature for sourdough?
Many bakers aim for about 24–25 °C (75–78 °F) for white-flour sourdough. The Perfect Loaf lowers the target slightly for mostly whole-grain doughs, because they ferment faster.
How long is bulk fermentation in a cold kitchen?
In The Perfect Loaf's examples, a dough at about 20 °C (68 °F) can need 6 to 8 hours, compared with roughly 4 hours at 24 °C.
Should I end bulk by time or by rise?
By rise, adjusted for temperature. The Sourdough Journey suggests ending earlier (around 30% rise) for a warm dough at 27 °C that goes into the fridge, and later (around 75%) for a cool dough at 21 °C.
Sources
- The Importance of Dough Temperature in Baking — The Perfect Loaf (2026-03-24)
- Dough Temping for Perfect Sourdough Fermentation — The Sourdough Journey (2024-05-16)
- Modeling of Growth of Lactobacillus sanfranciscensis and Candida milleri in Response to Process Parameters of Sourdough Fermentation — Applied and Environmental Microbiology (1998-07-01)
- Sourdough Starter — King Arthur Baking